REVOPOINT POP 4: A Practical First-Scan Workflow

1. Make the first object easy to scan

Choose an object that stays still and has recognisable shape changes. Leave enough room to move around it without pulling cables or knocking the support. A complicated transparent or highly polished part makes it harder to separate setup problems from surface problems.

Decide what you need from the result: overall form, small geometric details or a coloured visual model. That choice should guide your scanning approach and later processing, rather than selecting the most demanding options for every project.

2. Confirm connection before changing settings

Use the official software download centre to check the supported POP 4 software and computer or mobile requirements. Connect using the method specified for your equipment, then confirm the scanner appears and produces a usable live preview.

If the preview is absent or unstable, resolve the connection first. Changing exposure, fusion or mesh settings cannot repair a missing device connection. Save the project with a clear object name so later trial scans are easy to compare.

3. Check calibration and choose the capture approach

Review the manufacturer's calibration procedure and complete any check or calibration required for your situation. Use the correct calibration equipment and follow the illustrated sequence; avoid improvising target positions from memory.

Select a mode appropriate to the object's size, finish and detail. Take a short trial pass and inspect the data before a full rotation or longer handheld scan. If a surface is missing, investigate capture conditions before committing to the entire job.

Choose what moves before starting. For handheld capture, secure the object and move the scanner along an accessible route. For turntable capture, check the platform's size, load rating and clearance, secure the object and support the scanner steadily. Markers used as object references must stay fixed relative to the object; a stationary background is not a substitute for references travelling with the rotating part.

Neither arrangement is an automatic accuracy upgrade. Try a short pass or rotation, check tracking and coverage, then plan a separate view for the underside. Repositioned captures still need meaningful shared geometry for alignment. A basic rotating platform does not establish support for an automated turntable mode: check the POP 4 instructions and selected accessory before relying on software control.

4. Capture, inspect and keep a recoverable project

Move steadily and retain overlap between neighbouring views. Watch the live coverage as you approach edges, recesses and the underside. Pause to change position when necessary instead of sweeping quickly into an unseen area.

Inspect the point cloud before making a mesh. Remove unwanted background carefully, check alignment between passes and look for doubled surfaces. Preserve the raw project before hole filling or smoothing. Finally, open the exported model in its destination application and confirm scale, orientation and missing areas.